Waldschrat 0 #1 July 11, 2007 I bought a used second rig with a RavenIII 249ft^2 main. The Rig is a old PDF accuracy rig. It appears to me that the PC is too small, especially when i jump this rig with my wingsuits. The diameter is 58cm or 22,83" Material is ZP any opinions? Quote Share this post Link to post Share on other sites
masterrig 1 #2 July 11, 2007 I can recall when Raven III's were common as mains. Most folks I knew that jumped them, used 32" - 36" dia. pilot chutes... which was recommended. You want a pilot chute that will get that parachute out of the container and inflated. I'm not so sure about a 22" pilot chute, either. Chuck Quote Share this post Link to post Share on other sites
skybytch 273 #3 July 11, 2007 Quote I can recall when Raven III's were common as mains. Most folks I knew that jumped them, used 32" - 36" dia. pilot chutes... which was recommended. Same here. One difference though - those pilot chutes were built of F111, not zp. To the OP - you might try contacting Precision and see what they say. Quote Share this post Link to post Share on other sites
hookitt 1 #4 July 11, 2007 Too small, plain and simple. That's especially true if you fly a wingsuit. For general skydiving a 28 would be about right. If you fly a wingsuit then ideally an f-111 36. Current experienced wingsuit pilots would be a good source of info. Go ask or search the wingsuit forum this same question. Good luckMy grammar sometimes resembles that of magnetic refrigerator poetry... Ghetto Quote Share this post Link to post Share on other sites
masterrig 1 #5 July 12, 2007 To the OP - you might try contacting Precision and see what they say. ____________________________________ Always,the best advice... contact the manufacturer.Chuck Quote Share this post Link to post Share on other sites
hookitt 1 #6 July 12, 2007 Quote To the OP - you might try contacting Precision and see what they say. ____________________________________ Always,the best advice... contact the manufacturer.Thank you Captain Obvious There are a lot of wingsuit pilots that have more practical knowledge. Many are BASE enthusiasts with a very good understanding of flying a wingsuit and deployments. Parachute users are the reason manufacturers make changes.My grammar sometimes resembles that of magnetic refrigerator poetry... Ghetto Quote Share this post Link to post Share on other sites
Waldschrat 0 #7 July 12, 2007 Many thanks for your quick answers. I have an older (but not too old)F111 33" PC at home. I think, i try this size for the first jumps and buy next week a slightly bigger. Quote Share this post Link to post Share on other sites
hookitt 1 #8 July 12, 2007 Remember to ask in the wingsuit forum as well. If you do fly a wingsuit, remember a 9 foot bridle is highly suggested. (from pin to base of pilot chute). If the 33 is properly made and in good condition mounted on a 9 foot bridle, it would be fine. Good luck.My grammar sometimes resembles that of magnetic refrigerator poetry... Ghetto Quote Share this post Link to post Share on other sites
Waldschrat 0 #9 July 16, 2007 I try the 33"....very fast from throw to deployment, bridle attachment point looks also very good, after multiple speed deployments. thanks Quote Share this post Link to post Share on other sites