ChunkyT 0 #1 December 24, 2003 I know with bonehead helmets, you are able to bake the helmet and mold it to your head, but i was wondering if anything was different with the havok. i have heard suggestions along the lines of removing the ratcheting face shield and plastic so that it doesn't melt. however, if i do this, the helmet might not fit the way it's supposed to when i mold it. any suggestions of experience would be appreciated. We are creatures of the air, Our roots in dreams And clouds, reborn In flight. -Salmon Rushdie Quote Share this post Link to post Share on other sites
scottjaco 0 #2 December 24, 2003 I own a havok. You know that you are suppose to take the pads out of the helmet right? You don't put the whole helmet in the oven! I was told to take a bit of cardboard and set the pads on them so they weren't touching the metal. Then when they are hot enough, take them out and stick them back in the helmet and wear it for 30 minutes to create the mold. I haven't done this. My helmet feels fine the way it is. I have the medium sized pads which are already very comfortable. good luck Quote Share this post Link to post Share on other sites
Blahr 0 #3 December 25, 2003 You dont bake the whole helmet :-) Just the pads Quote Share this post Link to post Share on other sites
ChunkyT 0 #4 December 25, 2003 HAHAHA, well i'm glad i posted!!! Thanks for your help guys, that could have been catastrophic. We are creatures of the air, Our roots in dreams And clouds, reborn In flight. -Salmon Rushdie Quote Share this post Link to post Share on other sites